Refine
Year of publication
- 2017 (13) (remove)
Document Type
- Article (9)
- Doctoral Thesis (4)
Language
- English (13) (remove)
Has Fulltext
- yes (13)
Is part of the Bibliography
- no (13)
Keywords
- - (9)
- barrier discharge (3)
- gap voltage (2)
- inductively coupled plasma (2)
- laser photodetachment (2)
- memory effect (2)
- microwave interferometry (2)
- mode transition (2)
- negative ions (2)
- oxygen (2)
Institute
- Institut für Physik (13) (remove)
Publisher
- IOP Publishing (8)
- MDPI (1)
This thesis highlights the impact of surface charges and negative ions on the pre-ionization, breakdown mechanism, and lateral structure of dielectric barrier discharges operated in binary mixtures of helium with nitrogen or electronegative oxygen. Sophisticated diagnostic methods, e.g., non-invasive optical emission spectroscopy and the electro-optic Pockels effect as well as invasive laser photodetachment and laser photodesorption, were applied at one plane-parallel discharge configuration to investigate both relevant volume and surface processes. Moreover, the experimental findings were supported by numerical fluid simulations of the discharge. For the first time, the memory effect of the measured surface charge distribution was quantified and its impact on the local self-stabilization of discharge filaments was pointed out. As well, it turned out that a few additional seed electrons, either desorbed from the charged dielectric surface or detached from negative ions in the volume, significantly contribute to the pre-ionization resulting in a reduced voltage necessary for discharge breakdown. Finally, effective secondary electron emission coefficients of different dielectrics were estimated from the measured breakdown voltage using an analytical model.
Abstract
The laser photodetachment experiment in a diffuse helium–oxygen barrier discharge is evaluated by a 1D fluid simulation. As in the experiment, the simulated discharge operates in helium with
400
ppm
oxygen admixture at
500
mbar
inside a discharge gap of
3
mm
. The laser photodetachment is included by the interaction of negative ions with a temporally and spatially dependent photon flux. The simulation with the usually applied set of reactions and rate coefficients provides a much lower negative ion density than needed to explain the impact on the discharge characteristics in the experiment. Further processes for an enhanced negative ion formation and their capabilities of reproducing the experimental results are discussed. These further processes are additional attachment processes in the volume and the negative ion formation at the negatively charged dielectric. Both approaches are able to reproduce the measured laser photodetachment effect partially, but the best agreement with the experimental results is achieved with the formation of negative ions at the negatively charged dielectric.
Surface charge measurements on different dielectrics in diffuse and filamentary barrier discharges
(2017)
Abstract
Previously, we reported on the measurement of surface charges during the operation of barrier discharges (BDs) using the electro-optic Pockels effect of a bismuth silicon oxide (BSO) crystal. With the present work, the next milestone is achieved by making this powerful method accessible to various dielectrics which are typically used in BD configurations. The dynamics and spatial distribution of positive and negative surface charges were determined on optically transparent borosilicate glass, mono-crystalline alumina and magnesia, respectively, covering the BSO crystal. By variation of the nitrogen admixture to helium and the pressure between 500 mbar and 1 bar, both the diffuse glow-like BD and the self-stabilized discharge filaments were operated inside of a gas gap of 3 mm. The characteristics of the discharge and, especially, the influence of the different dielectrics on its development were studied by surface charge diagnostics, electrical measurements and ICCD camera imaging. Regarding the glow-like BD, the breakdown voltage changes significantly by variation of the cathodic dielectric, due to the different effective secondary electron emission (SEE) coefficients. These material-specific SEE yields were estimated using Townsend’s criterion in combination with analytical calculations of the effective ionization coefficient in helium with air impurities. Moreover, the importance of the surface charge memory effect for the self-stabilization of discharge filaments was quantified by the recalculated spatio-temporal behavior of the gap voltage.
Abstract
Single self-stabilized discharge filaments were investigated in the plane-parallel electrode configuration. The barrier discharge was operated inside a gap of 3 mm shielded by glass plates to both electrodes, using helium-nitrogen mixtures and a square-wave feeding voltage at a frequency of 2 kHz. The combined application of electrical measurements, ICCD camera imaging, optical emission spectroscopy and surface charge diagnostics via the electro-optic Pockels effect allowed the correlation of the discharge development in the volume and on the dielectric surfaces. The formation criteria and existence regimes were found by systematic variation of the nitrogen admixture to helium, the total pressure and the feeding voltage amplitude. Single self-stabilized discharge filaments can be operated over a wide parameter range, foremost, by significant reduction of the voltage amplitude after the operation in the microdischarge regime. Here, the outstanding importance of the surface charge memory effect on the long-term stability was pointed out by the recalculated spatio-temporally resolved gap voltage. The optical emission revealed discharge characteristics that are partially reminiscent of both the glow-like barrier discharge and the microdischarge regime, such as a Townsend pre-phase, a fast cathode-directed ionization front during the breakdown and radially propagating surface discharges during the afterglow.
Abstract
Alkali ion beams are among the most intense produced by the ISOLDE facility. These were the first to be studied by the ISOLTRAP mass spectrometer and ever since, new measurements have been regularly reported. Recently the masses of very neutron-rich and short-lived cesium isotopes were determined at ISOLTRAP. The isotope 148Cs was measured directly for the first time by Penning-trap mass spectrometry. Using the new results, the trend of two-neutron separation energies in the cesium isotopic chain is revealed to be smooth and gradually decreasing, similar to the ones of the barium and xenon isotopic chains. Predictions of selected microscopic models are employed for a discussion of the experimental data in the region.
Synopsis
Polyanionic metal clusters are produced by electron attachment in both Paul and Penning traps. After size and charge-state selection, the cluster properties are further investigated by various methods including photo-dissociation. Depending on the particular cluster species various decay modes are observed.
The content of this thesis can be summarized as follows: (i) The deposition processes of SiOx and SiOxCyHz coatings were investigated in a low-pressure, low temperature HMDSO-O2-N2 plasmas. Infrared laser absorption spectroscopy (IRLAS) and optical emission spectroscopy (OES) were combined to measure the gas temperatures in the hot and colder zones of the plasma as well as to monitor the concentration of the methyl radical, CH3, and of seven stable molecules, HMDSO, CH4, C2H2, C2H4, C2H6, CO and CO2. Tunable lead salt diode lasers (TDLs) and an external-cavity quantum cascade laser (EC-QCL) were simultaneously employed as radiation sources to perform the IRLAS measurements. They were found to be in the range between 10^{11} to 10^{15} cm^{−3}. The influence of the discharge parameters of power, pressure and gas mixture on the molecular concentrations was studied. The plasma generation is characterized by a certain degree of inhomogeneity with different temperature zones, i.e., hottest, hot and colder zones depending on the construction of the reactor. This complexity is characterized by the multiple molecular species including the HMDSO precursor and products in ground and excited states existing in the plasma. (ii) Employing similarly IRLAS and OES techniques, the deposition of nanocrystalline diamond at relatively low temperature in low-pressure MW H2 plasmas with small ad-mixtures of methane and carbon dioxide was investigated. Five methods were applied for an extensive temperature analysis, providing new insights into energetic aspects of the multi-component non-equilibrium plasma. The OES method provided information about the gas temperature of H2 inside the MW plasma. Using lead salt diode lasers, the rotational temperature of the methyl radical, CH3 , and gas temperature of methane molecule, CH4 , was measured. A variety of CO lines in the ground and in three excited states have been analysed using an EC-QCL with a relatively wide spectral range. These methods have shown that based on the construction of the DAA reactor using 16 single plasma sources the plasma generation is characterized by a variety of hottest, hot and colder zones. Extensive measurement of these various species temperatures in the complex plasma enabled the concentration determination of the various stable and unstable plasma species, which were found to be in the range between 10 11 to 10 15 cm −3 . The influence of the discharge parameters, power and pressure, on the molecular concentrations has been studied. To achieve insight into general plasma chemical aspects, the dissociation of the carbon precursor gases including their fragmentation and conversion to the reaction products was analysed in detail. The evolution of the concentration of the methyl radical, CH 3 , of five stable molecules, CH4, CO2, CO, C2H2 and C2H4, and of vibrationally excited CO in the first and second hot band was monitored in the plasma processes by in situ infrared laser absorption spectroscopy using lead salt diode lasers (TDL) and an external-cavity quantum cascade laser (EC-QCL) as radiation sources. OES was applied simultaneously to obtain complementary information about the degree of dissociation of the H2 precursor gas. The analysis of the carbon and oxygen mass balances shows clearly, that the deposition on the reactor walls and the production of other hydrocarbons species may act as sinks for carbon and oxygen. (iii) The absolute line strengths of many P-branch transitions of the ν3 fundamental of {28}^SiH4 were determined using the wide tuning range and the narrow line width of a cw EC-QCL between 2096 and 2178 cm^{−1}. The line positions and line strengths of transitions of the stretching dyad within the P-branch of {28}^SiH4 were determined with an estimated experimental measurement accuracy of 10%. The high spectral resolution available has enabled us to resolve and measure representative examples of the tetrahedral splittings associated with each component of the P-branch. The positions of these components are in excellent agreement with spherical top data system (STDS) predictions and theoretical transitions from the TDS spectroscopic database for spherical top molecules. To our knowledge, this is the first reported measurement of these line strengths in this band and is an example of the applicability of high-powered, widely tunable EC-QCLs to high resolution spectroscopy in the MIR. (iv) Similarly, the determination of the silyl radicals, ν3 band, line strengths is ongoing using the same cw EC-QCL. This effort was impaired by silane and other unknown species lines overlap; however, the silyl radicals was successfully detected in a SiH4/H2 plasma. A method to determine the silyl line strengths has been presented through its iterative decay measurements which relied on the value of the silyl radical self reaction constant. There was a consensus of its value in the literature.
Abstract
In this series of two papers we present results about the E-H transition of an inductively coupled oxygen discharge driven at radio frequency (13.56 MHz) for different total gas pressures. The mode transition from the low density E-mode to the high density H-mode is studied using comprehensive plasma diagnostics. The measured electron density can be used to distinguish between the different operation modes. This paper focuses on the determination of the negative atomic ion density and the electronegativity by two experimental methods and global rate equation calculation. As a result, the electronegativity significantly decreases over two orders of magnitude from about 25 in the E-mode to about 0.1 in the H-mode. The temporal behavior of the electronegativity in pulsed ICP shows that the negative atomic ion density reaches a steady state after 10 ms. Negative atomic ions are mainly produced by the dissociative attachment with the molecular ground state. The ion–ion recombination with the positive molecular ions and the collisional detachment with the singlet molecular metastables contribute significantly to the loss of the negative atomic ions.
Abstract
In this series of two papers, the E-H transition in a planar inductively coupled radio frequency discharge (13.56 MHz) in pure oxygen is studied using comprehensive plasma diagnostic methods. The electron density serves as the main plasma parameter to distinguish between the operation modes. The (effective) electron temperature, which is calculated from the electron energy distribution function and the difference between the floating and plasma potential, halves during the E-H transition. Furthermore, the pressure dependency of the RF sheath extension in the E-mode implies a collisional RF sheath for the considered total gas pressures. The gas temperature increases with the electron density during the E-H transition and doubles in the H-mode compared to the E-mode, whereas the molecular ground state density halves at the given total gas pressure. Moreover, the singlet molecular metastable density reaches 2% in the E-mode and 4% in the H-mode of the molecular ground state density. These measured plasma parameters can be used as input parameters for global rate equation calculations to analyze several elementary processes. Here, the ionization rate for the molecular oxygen ions is exemplarily determined and reveals, together with the optical excitation rate patterns, a change in electronegativity during the mode transition.