Refine
Document Type
- Doctoral Thesis (2)
Has Fulltext
- yes (2)
Is part of the Bibliography
- no (2)
Keywords
- Isomerisierungsreaktion (2) (remove)
Institute
Bisphenol A (BPA) ist ein Umweltschadstoff, der für die Produktion von Polykarbonatplastik und Epoxydharzen verwendet wird. Aufgrund seiner weltweiten Verbreitung, seiner Persistenz in der Umwelt und vor allen Dingen wegen seiner endokrinen Wirkung, stellt diese Verbindung eine große Gefahr für die Tier- und Pflanzenwelt sowie für den Menschen dar. Deshalb wurde aus einem bepflanzten Festbettreaktor, welcher mit BPA behandelt wurde, der Bakterienstamm RW4 isoliert, der fähig ist Bisphenol A als alleinige Kohlenstoff- und Energiequelle zu nutzen. Das Gram-negative Bakterium wurde mittels 16S rRNA-Analyse als Cupriavidus basilensis identifiziert und mittel der BIOLOG-Methode charakterisiert. Der Bakterienstamm kann ein sehr großes Spektrum an aliphatischen Stoffen wie Aceton, Ethanol, 1-Oktanol und aromatischen Verbindungen wie Phenol, Mono- und Dihydroxybenzoesäuren für das Wachstum nutzen. C. basilensis RW4 baut Bisphenol A nur sehr langsam ab. Es ist jedoch möglich den BPA-Abbau sowohl in Schüttelkulturen und als auch in kontinuierlich laufenden Sandsäulen durch Zugabe von Phenol als Co-Substrat und Wachstumsstimulanz deutlich zu steigern. Die erfassten Abbauintermediate wie 4-Hydroxyacetophenon und 2-(4-Propanol)-phenol wiesen darauf hin, dass C. basilensis RW4 einen ähnlichen Abbauweg nutzt wie Sphingomonas sp. TTNP3 von Kolvenbach et al. (2007) nutzt. In weiteren Untersuchungen, wurde die toxische Wirkung von Bisphenol A auf den Standardmikroorganismus Pseudomonas putida P8 in Schüttelkulturen und in kontinuierlich laufenden Sandsäulen analysiert. Es zeigte sich, dass BPA das Wachstum von P. putida P8 hemmt und Modifikationen in der Zusammensetzung der Phospholipide in der Membran hervorruft. P. putida P8 reagierte unmittelbar auf das Einwirken von BPA auf der Membranebene durch Veränderung des Verhältnisses der trans-ungesättigten Fettsäuren zu den cis-ungesättigten Fettsäuren, was schon in früheren Untersuchungen für andere organische Lösungsmittel beschrieben wurde. Dementsprechend wurde eine Korrelation zwischen der BPA-Konzentration und dem Anstieg des trans-cis-Verhältnisses ermittelt. Weil diese Anpassungsreaktion eine kurzfristige Antwort auf den einwirkenden Stressor ist, konnte der Anstieg des trans-cis-Verhältnisses nur kurz nach BPA-Zugabe erfasst werden. Somit kann das trans-cis-Verhältnis nur als temporärer Biomarker für die Toxizität von BPA in Schüttelkulturen genutzt werden, jedoch nicht in langfristig laufenden Sandsäulen.
The toluene-degrading and solvent-tolerant strain Pseudomonas putida DOT-T1E was investigated with respect to its suitability and economic efficiency as biocatalyst in aqueous-organic two-phase systems with aliphatic solvents as organic phase (Rojas et al. 2004, chapter 4 and 5) and to its adaptive responses to the solvent decanol. The adaptive changes on the level of cell morphology (chapter 2), membrane fatty acids and permeability (chapter 3), as well as energetics and surface properties (chapter 5) of P. putida DOT-T1E have been investigated in order to ascertain information about the strain's suitability for two-phase biotransformation systems (chapter 4). The morphological adaptation to the presence of solvents was observable in changes of the cell size of P. putida DOT-T1E. Those changes were dependent on the cellular activity and occurred only after addition of non-lethal solvent concentrations. The cells reacted to the presence of organic solvents by decreasing the ratio between surface and volume of the cells and therefore reducing their relative surfaces (chapter 2). The cell surface and especially the cytoplasmic membrane are the major targets for toxic effects of membrane-active compounds like solvents. The mechanism of the cis-trans isomerisation of unsaturated fatty acids counteracts the fluidizing effect of solvents by increase the ordering of the membrane and therefore its rigidity. By comparing the responses of the cells to a series of stress factors (like solvents), a direct correlation between the activation of this mechanism and the well investigated K+-uptake pumps was observed (chapter 3). Huertas et al. (1998) reported that this strain tolerated concentrations of heptane, propylbenzene, octanol, and toluene of at least 10 % (vol/vol). 1-decanol is, in comparison to toluene, less hazardous and volatile, and it possesses good extraction properties for the desired fine chemical products. In further investigations of possible biotechnological processes, it was discovered that decanol is also a more suitable solvent as organic phase (chapter 4). Although the cells of P. putida DOT-T1E needed additional energy for their adaptation to the presence of the solvent decanol, they were able to maintain or activate their electron transport phosphorylation allowing homeostasis of ATP level and energy charge in the presence of the solvent, at the price of a reduced growth yield. On the other hand, significantly enhanced cell hydrophobicities converging with more negative cell surface charges were observed in cells grown in the presence of 1-decanol (chapter 5). It is however important to note that all the cell’s properties observed are closely linked to each other since they are all part of the adaptive response of the cells. It can be concluded that the easy adaptability and good growth properties of Pseudomonas putida DOT-T1E in the presence of the organic solvent 1-decanol make this system an excellent candidate for two-phase fermentation processes. Moreover, the absence of differences in the energetics of the bacteria during exposure to 1-decanol as compared to bacteria that grew in the absence of 1-decanol, support that this organism can be used for the industrial production of fine chemicals in an economically sound manner.