Refine
Year of publication
- 2017 (5)
Document Type
- Article (4)
- Doctoral Thesis (1)
Language
- English (5)
Has Fulltext
- yes (5) (remove)
Is part of the Bibliography
- no (5)
Keywords
- - (4)
- barrier discharge (3)
- gap voltage (2)
- memory effect (2)
- negative ions (2)
- pre-ionization (2)
- surface charge (2)
- Barrierenentladung (1)
- Niedertemperaturplasma (1)
- Oberflächenladungen (1)
- Plasmadiagnostik (1)
- Sekundärelektronen (1)
- Vorionisation (1)
- alumina (1)
- borosilicate (1)
- discharge mode transition (1)
- fluid simulation (1)
- glow-like discharge (1)
- helium barrier discharge (1)
- helium–oxygen barrier discharge (1)
- laser photodesorption (1)
- laser photodetachment (1)
- magnesia (1)
- microdischarge (1)
- negative Ionen (1)
- patterned discharge (1)
- secondary electron emission coefficient (1)
- secondary electrons (1)
- seed electrons (1)
- surface charges (1)
- surface electrons (1)
Institute
- Institut für Physik (5) (remove)
Publisher
- IOP Publishing (4)
Abstract
The presented work highlights the role of residual weakly-bound surface electrons acting as an effective seed electron reservoir that favors the pre-ionization of diffuse barrier discharges (BDs). A glow-like BD was operated in helium at a pressure of 500 mbar in between two plane electrodes each covered with float glass at a distance of
3 mm.The change in discharge development due to laser photodesorption of surface electrons was studied by electrical measurements and optical emission spectroscopy. Moreover, a 1D numerical fluid model of the diffuse discharge allowed the simulation of the laser photodesorption experiment, the estimation of the released surface electrons, and the understanding of their impact on the reaction kinetics in the volume. The breakdown voltage is clearly reduced when the laser beam at photon energy of 2.33 eV hits the cathodic dielectric that is charged with residual electrons during the discharge pre-phase. According to the adapted simulation, the laser releases only a small amount of surface electrons in the order of
10 pC. Nevertheless, this significantly supports the pre-ionization. Using a lower photon energy of 1.17 eV, the transition from the glow mode to the Townsend mode is induced due to a much higher electron yield up to 1 nC. In this case, both experiment and simulation indicate a retarded stepwise release of surface electrons initiated by the low laser photon energy.
Abstract
Single self-stabilized discharge filaments were investigated in the plane-parallel electrode configuration. The barrier discharge was operated inside a gap of 3 mm shielded by glass plates to both electrodes, using helium-nitrogen mixtures and a square-wave feeding voltage at a frequency of 2 kHz. The combined application of electrical measurements, ICCD camera imaging, optical emission spectroscopy and surface charge diagnostics via the electro-optic Pockels effect allowed the correlation of the discharge development in the volume and on the dielectric surfaces. The formation criteria and existence regimes were found by systematic variation of the nitrogen admixture to helium, the total pressure and the feeding voltage amplitude. Single self-stabilized discharge filaments can be operated over a wide parameter range, foremost, by significant reduction of the voltage amplitude after the operation in the microdischarge regime. Here, the outstanding importance of the surface charge memory effect on the long-term stability was pointed out by the recalculated spatio-temporally resolved gap voltage. The optical emission revealed discharge characteristics that are partially reminiscent of both the glow-like barrier discharge and the microdischarge regime, such as a Townsend pre-phase, a fast cathode-directed ionization front during the breakdown and radially propagating surface discharges during the afterglow.
Surface charge measurements on different dielectrics in diffuse and filamentary barrier discharges
(2017)
Abstract
Previously, we reported on the measurement of surface charges during the operation of barrier discharges (BDs) using the electro-optic Pockels effect of a bismuth silicon oxide (BSO) crystal. With the present work, the next milestone is achieved by making this powerful method accessible to various dielectrics which are typically used in BD configurations. The dynamics and spatial distribution of positive and negative surface charges were determined on optically transparent borosilicate glass, mono-crystalline alumina and magnesia, respectively, covering the BSO crystal. By variation of the nitrogen admixture to helium and the pressure between 500 mbar and 1 bar, both the diffuse glow-like BD and the self-stabilized discharge filaments were operated inside of a gas gap of 3 mm. The characteristics of the discharge and, especially, the influence of the different dielectrics on its development were studied by surface charge diagnostics, electrical measurements and ICCD camera imaging. Regarding the glow-like BD, the breakdown voltage changes significantly by variation of the cathodic dielectric, due to the different effective secondary electron emission (SEE) coefficients. These material-specific SEE yields were estimated using Townsend’s criterion in combination with analytical calculations of the effective ionization coefficient in helium with air impurities. Moreover, the importance of the surface charge memory effect for the self-stabilization of discharge filaments was quantified by the recalculated spatio-temporal behavior of the gap voltage.
This thesis highlights the impact of surface charges and negative ions on the pre-ionization, breakdown mechanism, and lateral structure of dielectric barrier discharges operated in binary mixtures of helium with nitrogen or electronegative oxygen. Sophisticated diagnostic methods, e.g., non-invasive optical emission spectroscopy and the electro-optic Pockels effect as well as invasive laser photodetachment and laser photodesorption, were applied at one plane-parallel discharge configuration to investigate both relevant volume and surface processes. Moreover, the experimental findings were supported by numerical fluid simulations of the discharge. For the first time, the memory effect of the measured surface charge distribution was quantified and its impact on the local self-stabilization of discharge filaments was pointed out. As well, it turned out that a few additional seed electrons, either desorbed from the charged dielectric surface or detached from negative ions in the volume, significantly contribute to the pre-ionization resulting in a reduced voltage necessary for discharge breakdown. Finally, effective secondary electron emission coefficients of different dielectrics were estimated from the measured breakdown voltage using an analytical model.
Abstract
The laser photodetachment experiment in a diffuse helium–oxygen barrier discharge is evaluated by a 1D fluid simulation. As in the experiment, the simulated discharge operates in helium with
400
ppm
oxygen admixture at
500
mbar
inside a discharge gap of
3
mm
. The laser photodetachment is included by the interaction of negative ions with a temporally and spatially dependent photon flux. The simulation with the usually applied set of reactions and rate coefficients provides a much lower negative ion density than needed to explain the impact on the discharge characteristics in the experiment. Further processes for an enhanced negative ion formation and their capabilities of reproducing the experimental results are discussed. These further processes are additional attachment processes in the volume and the negative ion formation at the negatively charged dielectric. Both approaches are able to reproduce the measured laser photodetachment effect partially, but the best agreement with the experimental results is achieved with the formation of negative ions at the negatively charged dielectric.